Re: Trying to set up a router
Don't use the software, you don't need to.
Plug your internet (cable, dsl, whatever) into the router's WAN/Internet port
Plug your computer into one of the LAN ports
Make sure your computer is set to obtain an IP address automatically (DHCP=on)
Go to a CMD prompt (run-->cmd)
type in ipconfig
Your IP address should be something like 192.168.1.100
Your gateway should be 192.168.1.1
If these numbers don't match up, type an ipconfig /release, then ipconfig /renew. This will get a new IP address from your router
Go in internet explorer to 192.168.1.1. Log in with the default username/password specified in your manual or quickstart guide
Change any settings you need to
Profit
|